U.S. PHARMACOPEIA

Search USP29  
Acyclovir Oral Suspension
» Acyclovir Oral Suspension contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of acyclovir (C8H11N5O3).
Packaging and storage— Preserve in tight containers. Store between 15 and 25. Protect from light.
Identification— The retention time of the major peak in the chromatogram of the Assay preparation corresponds to that in the chromatogram of the Standard preparation, as obtained in the Assay.
Uniformity of dosage units 905
FOR ORAL SUSPENSION PACKAGED IN SINGLE-UNIT CONTAINERS: meets the requirements.
Deliverable volume 698
FOR ORAL SUSPENSION PACKAGED IN MULTIPLE-UNIT CONTAINERS: meets the requirements.
pH 791: between 4.5 and 7.0.
Microbial limits 61 Its total count does not exceed 10 cfu per mL, and it meets the requirements of the tests for absence of Salmonella species and Escherichia coli.
Limit of guanine—
Mobile phase and Chromatographic system— Proceed as directed in the Assay.
Standard solution— Dissolve an accurately weighed quantity of guanine in 0.1 M sodium hydroxide, and dilute quantitatively, and stepwise if necessary, with 0.1 M sodium hydroxide to obtain a solution having a known concentration of about 2.0 µg per mL.
Test solution— Use the Assay preparation.
Procedure— Separately inject equal volumes (about 20 µL) of the Standard solution and the Test solution into the chromatograph, record the chromatograms, and measure the peak responses. Calculate the percentage of guanine in the portion of Oral Suspension taken by the formula:
100(C/D)(rU / rS),
in which C is the concentration, in mg per mL, of guanine in the Standard solution; D is the concentration, in mg per mL, of acyclovir in the Test solution; and rU and rS are the guanine peak responses obtained from the Test solution and the Standard solution, respectively: not more than 2.0% is found.
Residual solvents 467: meets the requirements.
(Official January 1, 2007)
Assay—
Mobile phase— Prepare a filtered and degassed solution of 0.02 M acetic acid. Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard preparation— Dissolve an accurately weighed quantity of USP Acyclovir RS in 0.1 N sodium hydroxide, and dilute quantitatively, and stepwise if necessary, with 0.1 N sodium hydroxide to obtain a solution having a known concentration of 0.1 mg per mL.
System suitability preparation 1— Dissolve accurately weighed quantities of USP Acyclovir RS and guanine in 0.1 N sodium hydroxide, and dilute quantitatively, and stepwise if necessary, with 0.1 N sodium hydroxide to obtain a solution having known concentrations of about 0.1 mg of each per mL.
System suitability preparation 2— Dissolve an accurately weighed quantity of guanine in 0.1 N sodium hydroxide, and dilute quantitatively, and stepwise if necessary, with 0.1 N sodium hydroxide to obtain a solution having a known concentration of about 2.0 µg per mL.
Assay preparation— Transfer an accurately measured quantity of well-shaken Oral Suspension, equivalent to about 200 mg of acyclovir, to a 200-mL volumetric flask, add 100 mL of 0.1 N sodium hydroxide, shake by mechanical means for 15 minutes, and sonicate, if necessary, to dissolve the Oral Suspension completely. Dilute with 0.1 N sodium hydroxide to volume, and mix. Transfer 10.0 mL of the solution to a 100-mL volumetric flask, dilute with water to volume, mix, and filter.
Chromatographic system (see Chromatography 621)— The liquid chromatograph is equipped with a 254-nm detector and a 4.6-mm × 25-cm column that contains packing L1. The flow rate is about 3 mL per minute. Chromatograph System suitability preparation 1, and record the peak responses as directed for Procedure: the relative retention times are about 0.6 for guanine and 1.0 for acyclovir; the resolution, R, between guanine and acyclovir is not less than 2.0; and the relative standard deviation for replicate injections for the acyclovir is not more than 2.0%. Chromatograph System suitability preparation 2, and record the peak responses as directed for Procedure: the relative standard deviation for replicate injections is not more than 2.0%.
Procedure— Separately inject equal volumes (about 20 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the peak responses. Calculate the quantity, in mg, of acyclovir (C8H11N5O3) in the portion of Oral Suspension taken by the formula:
100C(rU / rS),
in which C is the concentration, in mg per mL, of USP Acyclovir RS in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information— Staff Liaison : Behnam Davani, Ph.D., MBA, Senior Scientist
Expert Committee : (MDAA05) Monograph Development-Antivirals and Antimicrobials
USP29–NF24 Page 56
Pharmacopeial Forum : Volume No. 30(2) Page 435
Phone Number : 1-301-816-8394