U.S. PHARMACOPEIA

Search USP29  
Mesalamine
Click to View Image
C7H7NO3 153.14

Benzoic acid, 5-amino-2-hydroxy-.
5-Aminosalicylic acid [89-57-6].
» Mesalamine contains not less than 98.5 percent and not more than 101.5 percent of C7H7NO3, calculated on the dried basis.
Packaging and storage— Preserve in tight, light-resistant containers.
Clarity of solution— A freshly prepared solution of 0.25 g of it in 10 mL of 1 N hydrochloric acid is clear.
Identification—
B: Ultraviolet Absorption 197U
Solution: 12 µg per mL.
Medium: 0.1 N hydrochloric acid.
Absorptivities at 230 nm do not differ by more than 3.0%.
C: Dissolve about 100 mg of it in 5 mL of 0.1 N hydrochloric acid, and add 1 drop of ferric chloride TS: a purplish-violet color is produced.
pH 791: between 3.5 and 4.5, in a suspension (1 in 40).
Loss on drying 731 Dry it in vacuum at 105 for 3 hours: it loses not more than 0.5% of its weight.
Residue on ignition 281: not more than 0.2%.
Chloride 221 Disperse 500 mg in 40 mL of water, sonicate for 5 minutes, and filter the dispersion. To the filtrate add 1 mL of nitric acid: the solution shows no more chloride than corresponds to 0.7 mL of 0.020 N hydrochloric acid (0.1%).
Heavy metals, Method II 231: 0.002%.
Hydrogen sulfide and sulfur dioxide— Dissolve about 500 mg in 5 mL of 1 N sodium hydroxide, add 6 mL of 3 N hydrochloric acid, and stir vigorously. A piece of moistened lead acetate test paper held over the mixture does not become discolored.
Sulfate— Proceed as directed in the test for Sulfate 221: a 500-mg portion shows no more sulfate than corresponds to 1.0 mL of 0.02 N sulfuric acid (0.2%).
Change to read:
Related compounds—
TEST 1 (for 3-aminosalicylic acid and other related impurities)— [NOTE—Use Test 1 to measure 3-aminosalicylic acid and other related impurities not measured in Test 2.]
Mobile phase— Dissolve 1.36 g of monobasic potassium phosphate and 2.2 g of sodium 1-octanesulfonate in 890 mL of water, and adjust with phosphoric acid to a pH of 2.2. Pass through a filter having a 0.5-µm or finer porosity. To the filtrate add 80 mL of methanol and 30 mL of acetonitrile. Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard solution— Quantitatively dissolve accurately weighed quantities of USP Mesalamine RS and 3-aminosalicylic acid in Mobile phase to obtain a solution having known concentrations of about 1 µg of each per mL.
Test solution— Transfer about 50 mg of Mesalamine, accurately weighed, to a 100-mL volumetric flask, add about 75 mL of Mobile phase, and sonicate briefly to dissolve. Dilute with Mobile phase to volume, and mix.
Chromatographic system (see Chromatography 621)— The liquid chromatograph is equipped with a 220-nm detector and a 4.6-mm × 15-cm column that contains 5-µm packing L7. The flow rate is about 1.2 mL per minute. Chromatograph the Standard solution, and record the peak responses as directed for Procedure: the relative retention times are about 1.0 for mesalamine and 1.3 for 3-aminosalicylic acid; and the resolution, R, between mesalamine and 3-aminosalicylic acid is not less than 2.
Procedure— Separately inject equal volumes (about 20 µL) of the Standard solution and the Test solution into the chromatograph, record the chromatograms for a period of time that is three times the retention time of mesalamine, and measure the peak area responses. Calculate the percentage of 3-aminosalicylic acid by the formula:
0.2C3(r3 / rS3)
in which C3 is the concentration, in µg per mL, of 3-aminosalicylic acid in the Standard solution; r3 is the response of the 3-aminosalicylic acid peak in the chromatogram obtained from the Test solution; and rS3 is the response of the 3-aminosalicylic acid peak in the chromatogram obtained from the Standard solution. Calculate the percentage of each other impurity by the formula:
0.2Cm(ri / rSm)
in which Cm is the concentration, in µg per mL, of USP Mesalamine RS in the Standard solution; ri is the response of the individual impurity peak in the chromatogram obtained from the Test solution; and rSm is the response of the mesalamine peak in the chromatogram obtained from the Standard solution: not more than 0.2% of 3-aminosalicylic acid is found; not more than 0.2% of any other impurity, expressed in terms of mesalamine equivalent, is found; and the total of all impurities found is not more than 1.0%.
TEST 2 (for aniline, 2-aminophenol, and 4-aminophenol)—
Standard solution— Prepare a solution of aniline, 2-aminophenol, and 4-aminophenol in methanol having concentrations of 0.05, 2, and 2 mg per mL, respectively; and dilute quantitatively, and stepwise if necessary, with methylene chloride to obtain a solution having concentrations of 0.5, 20, and 20 µg per mL, respectively.
Test solution— Mix 1.0 g of Mesalamine with 10.0 mL of methylene chloride. Allow to settle, and use the clear methylene chloride solution as the Test solution.
Chromatographic system (see Chromatography 621)— The gas chromatograph is equipped with a flame-ionization detector and a 0.53-mm × 10-m fused-silica capillary column coated with a 2.65-µm film of stationary phase G27. The carrier gas is helium flowing at a rate of 15 mLUSP29 per minute. The injection port and the detector temperatures are maintained at about 280 and 300, respectively. The column temperature is programmed according to the following steps: the starting column temperature is 70; after injection it is held at 70 for 2 minutes, then increased to 150 at a rate of 30 per minute, then held for 1 minute. Chromatograph the Standard solution, and record the peak responses as directed for Procedure: the relative retention times are about 0.5 for aniline, 0.9 for 2-aminophenol, and 1.0 for 4-aminophenol; and the peaks are baseline separated.
Procedure— Separately inject equal volumes (about 2 µL) of the Standard solution and the Test solution into the chromatograph, record the chromatograms, and measure the peak area responses. Identify by retention time any peaks present in the chromatogram of the Test solution that correspond to those in the chromatogram obtained from the Standard solution. Calculate the quantities, in µg per g, of aniline, 2-aminophenol, and 4-aminophenol in the portion of Mesalamine taken by the formula:
10C(ra / rSa)
in which C is the concentration, in µg per mL, of the relevant analyte in the Standard solution; ra is the response of the relevant analyte in the chromatogram obtained from the Test solution; and rSa is the response of the relevant analyte in the chromatogram obtained from the Standard solution: not more than 5 µg of aniline, 200 µg of 2-aminophenol, and 200 µg of 4-aminophenol per g are found.
Residual solvents 467: meets the requirements.
(Official January 1, 2007)
Assay—
Buffer solution— Transfer 7.1 g of anhydrous dibasic sodium phosphate and 6.9 g of monobasic sodium phosphate to a 1000-mL volumetric flask, add 500 mL of water, and swirl to dissolve. Add 7.5 mL of a solution of tetrabutylammonium hydroxide in methanol (1 in 4), dilute with water to volume, and mix.
Mobile phase— Prepare a suitable degassed mixture of Buffer solution and methanol (85:15). Make adjustments if necessary (see System Suitability under Chromatography 621).
Resolution solution— Prepare a solution in Mobile phase containing about 0.25 mg of 4-aminosalicylic acid and 0.4 mg of USP Mesalamine RS per mL.
Standard preparation— Quantitatively dissolve an accurately weighed quantity of USP Mesalamine RS in Mobile phase to obtain a solution having a known concentration of about 1 mg per mL. Transfer 10.0 mL of this solution to a 25-mL volumetric flask, dilute with Mobile phase to volume, and mix. This solution contains about 0.4 mg of USP Mesalamine RS per mL.
Assay preparation— Transfer about 50 mg of Mesalamine, accurately weighed, to a 50-mL volumetric flask, dissolve in and dilute with Mobile phase to volume, and mix. Transfer 10.0 mL of this solution to a 25-mL volumetric flask, dilute with Mobile phase to volume, and mix.
Chromatographic system (see Chromatography 621)— The liquid chromatograph is equipped with a 254-nm detector and a 4-mm × 30-cm column that contains packing L1. The flow rate is about 2 mL per minute. Chromatograph the Resolution solution, and record the peak responses as directed for Procedure: the resolution, R, between 4-aminosalicylic acid and mesalamine is not less than 2.0. Chromatograph the Standard preparation, and record the peak responses as directed for Procedure: the tailing factor is not more than 2.5; and the relative standard deviation for replicate injections is not more than 2.0%.
Procedure— Separately inject equal volumes (about 15 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of C7H7NO3 in the portion of Mesalamine taken by the formula:
125C(rU / rS)
in which C is the concentration, in mg per mL, of USP Mesalamine RS in the Standard preparation; and rU and rS are the responses of the mesalamine peaks obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information— Staff Liaison : Clydewyn M. Anthony, Ph.D., Scientist
Expert Committee : (MDCCA05) Monograph Development-Cough Cold and Analgesics
USP29–NF24 Page 1352
Pharmacopeial Forum : Volume No. 31(2) Page 424
Phone Number : 1-301-816-8139